top of page

S Box Ghost Scanner

S Box Ghost Scanner

THEORY: When a ghost/spirit is trying to communicate with you, it may do so by using different radio frequencies, for real time communication.


HOW TO USE:

  • Turn on the device by switching the power button on located at the top of the device. You may or may not use the antenna for better communication.

  • Choose either an AM or FM frequency by using the Mode Button. Note: The default setting is FM.

  • Hit the scan button to start or stop the scan.

  • Then press the sweep forward button.

  • Then choose the sweep rate. We recommend setting 3, which is 300ms (milliseconds). The sweep rate is the speed that the device will scan through each frequency.

  • To choose a lower setting press the left arrow and for a higher setting press the right arrow

  • At this point the device should start scanning. Make sure your volume control is loud enough for you to hear. The volume dial is located on the top of the device. (If the device is not loud enough then you can add external speakers.) Once the device is set up start recording the session with a digital audio recorder, or directly start recording within the device.

  • Press the record button. You will know the device is recording because it will show an SD on the screen. To stop recording press the record button again.

  • Set up a pre wrap with the digital recorder saying the time date and location, as well as an opening protection prayer. In the opening protection prayer, you should say “please protect me from any negative spirits out there, and only allow the positive spirits to come through.” You should only do 3-minute to 5-minute sessions at a time. At the end of each session, you need to do a close out prayer. In the close out prayer, you should say “whatever spirits that have come through this device must go back from where they came from and are not allowed to follow us home.” You may also say the prayer of St. Michael as well. Once you are done with your closing prayer turn the device off.


RANGE: The scan range for AM frequencies is 522kHz to 1710kHz. The sweep rate range for AM frequencies is 100milliseconds to 400milliseconds.


The scan range for FM frequencies is 87.5MHz to 108MHz. The sweep rate range for FM frequencies is 100milliseconds to 400milliseconds.

 

SPEED SETTINGS:

  • Setting 1 = 100ms

  • Setting 2 = 200ms

  • Setting 3 = 300ms

  • Setting 4 = 400ms


READINGS: When analyzing your recordings, you need to be extremely careful that you do not mistake normal radio broadcasts for spirit communication. Always have a second opinion on what you may have found before you put the analysis in a final field report. Make sure while analyzing your data that you understand what matrixing is. If you do happen to record something that is paranormal it is called RVP, Radio Voice Phenomenon, which is when you get disembodied voices through radio devices. This term should not be mistaken for EVP, Electronic Voice Phenomenon.

bottom of page